Click or drag to resize
XBee Commands

This application supports a few basic commands to support the operation multiple serial terminals.

API Enable

This enables API mode on the XBee modem connected to your PC. This setting does not save the the XBee's non-volatile storage. If you wish to have this change be permanent, please use XCTU to change the setting.

Set Broadcast

This sets the destination address of the XBee modem connected to your PC to broadcast. This setting does not save the the XBee's non-volatile storage. If you wish to have this change be permanent, please use XCTU to change the setting.

Set Coordinator

This changes the XBee modem connected to your PC to non routing coordinator mode. This setting does not save the the XBee's non-volatile storage. If you wish to have this change be permanent, please use XCTU to change the setting.

See Also

Other Resources

Digi XCTU Software